|
"You consider in environmental problem, use the
polyester film (the same material as PET bottle) to the PET seat, re-use of the
resource has become possible."
Procedure:
1. The JUIC PET glue sheet
2. Peel of the yellow sheet
3. Stick the sheet onto the clean blade surface using a roller to roll it
onto the blade. Start at the bottom (near the handle) and roll it on bit by bit.
Using the roller ensures that there are no air bubbles underneath.
4. Use scissors to neatly cut off the excess bits around the blade.
5. Peel off the white sheet which exposes the adhesive side as shown.
6. Stick the rubber onto the blade surface using a roller to roll it onto the
blade. Start at the bottom (near the handle) and roll it on bit by bit. Using
the roller ensures that there are no air bubbles underneath.
7. Use scissors to neatly cut off the excess rubber around the blade. Use the
roller once more to roll down the edges, and you're ready to play!
NOTES:
For the JUIC PET glue, the
adhesives used on the yellow side is different to that used on the white side.
Please follow the procedure carefully not to make mistakes.
When you need to peel the rubber off again, please take
great care and peel of very slowly to prevent any damage
|
